Tungsten carbide burrs with HICOAT coatings
PFERD TOOLS offers tungsten carbide burrs with HICOAT coatings to tackle particularly demanding applications. The anti-wear coatings enable effective chip removal thanks to the improved anti-adhesion characteristics and increase the tools' service life.
Two different coatings are available.
The HICOAT coating HC-FEP is specifically designed for iron and steel materials.
The HICOAT coating HC-NFE is mainly used for long-chipping and lubricating aluminium alloys and non-ferrous metals.
In general, all PFERD TOOLS tungsten carbide burrs are also available with HICOAT coatings.
Advantages:
- Improved anti-adhesion characteristics.
- Effective chip discharge.
- Lower thermal loads.
- Increased service life.
- Also suitable for use at higher cutting speeds when compared with uncoated burrs.
HICOAT coating HC-FEP for iron and steel materials
- High hardness and wear resistance.
- Effective chip removal through improved anti-adhesion characteristics.
- Very high resistance against thermal load.
- Increased service life.
- Also suitable for use at higher cutting speeds when compared with uncoated burrs.
ALU cut with HICOAT coating HC-NFE
The use of burrs with the PFERD TOOLS HICOAT coating HC-NFE prevents chips adhering during work on soft aluminium alloys. This increases the tool life and improves the surface quality of the workpiece.
- Mainly used for long-chipping and lubricating non-ferrous metals.
- Highest stock removal rate.
- Effective chip removal through improved anti-adhesion characteristics.
- Lower thermal loads.
- Longer service life.
