Tungsten carbide high-performance burr INOX oval TRE dia. 12x20 mm shank dia. 6 mm HICOAT stainless steel

Technical information

Cut: INOX HC-STS
Dia. external: 12 mm
Dia. shank: 6 mm
Length, cut: 20 mm
Length, total: 60 mm
RPM, hard non-ferrous metals: 7000 - 16000 RPM
RPM, rust and acid-resistant steels: 12000 - 20000 RPM
RPM, soft non-ferrous metals: 7000 - 16000 RPM
Radius corner design: 5 mm
Packaging unit: 1 piece

Description

High-performance cut INOX with HICOAT coating HC-STS is characterized by its high degree of hardness and wear resistance. It enables effective chip removal through improved anti-adhesion characteristics and is highly temperature-resistant. It allows for a longer tool life and use at higher cutting speeds in comparison with uncoated burrs.

Oval burr according to DIN 8032.

Special features

The highly accurate concentricity enables impactfree working without creating chatter marks. This considerably reduces wear on the tool and tool drive.

Recommendations for use

To ensure costeffective use of burrs, use a higher rotational speed and cutting speed. Use burrs with a shank diameter of 6 mm with drives with a power output from 300 watts.

Safety notes

The very high stock removal rate can cause discolouration on the shank. This does not constitute a safety risk.

Materials that can be worked: Case-hardened steels; Cast steel; Hardened, heat-treated steels over 1.200 N/mm² (< 38 HRC); Hard non-ferrous metal; Stainless steel (INOX); Steel; Steel, cast steel; Steels over 700 N/mm² (> 220 HB); Steels up to 1,200 N/mm² (< 38 HRC); Steels up to 700 N/mm² (< 220 HB); Titanium; Titanium alloys; Tool steels